สำหรับการใช้งานแอปของเราและการตั้งค่า โปรด ลงชื่อเข้าใช้บัญชี ExpressVPN ก่อน

This tutorial will show you how to set up ExpressVPN on your D-Link router using L2TP.

Important: L2TP does not offer any encryption and should only be used for anonymization or for changing locations.

The steps below were tested on D-Link DIR-842. Some D-Link models require IP addresses instead of server names for the L2TP manual configuration, while other models (e.g., DSL-225) may not support VPN clients.

If you are unable to follow the steps below because your device interface looks drastically different, contact the ExpressVPN Support Team for assistance.

Jump to…

1. Find your ExpressVPN account credentials
2. Configure your D-Link router with the VPN
Disconnect from a VPN server location


1. Find your ExpressVPN account credentials

Go to the ExpressVPN setup page. If prompted, enter your ExpressVPN credentials and click Sign In.

Enter your account credentials, then click "Sign In."

Enter the verification code that is sent to your email.

On the right, select PPTP & L2TP/IPsec.

Click "PPTP & L2TP/IPsec."

This will show you your username, password, and a list of server addresses around the world.

This will show you your username, password, and a list of server addresses around the world.

Keep this browser window open. You will need this information for the setup later.

Need help? Contact the ExpressVPN Support Team for immediate assistance.

Back to top


2. Configure your D-Link router with the VPN

In your browser’s address bar, enter dlinkrouter.local to access the router admin panel.

Enter your admin password. Click Log In.

Click “Log In.”

In the top menu bar, click Settings > Internet.

Click “Internet.”

Enter the following information:

  • My Internet Connection is: Select L2TP.
  • L2TP server IP address: Enter the server address you found earlier.
  • Username: Enter the username you found earlier.
  • Password: Enter the password you found earlier.
  • Reconnect Mode: Select On demand.
  • Maximum idle time: Select 1.

Click Save.

Click “Save.”

After the new settings have been saved, you should be connected to ExpressVPN.

To confirm that the VPN connection is working, you can check your IP address.

Need help? Contact the ExpressVPN Support Team for immediate assistance.

Back to top


Disconnect from a VPN server location

To disconnect from a VPN server location, go to Settings > Internet.

For My Internet Connection is, select Dynamic IP (DHCP) > Save.

Click “Save.”

You are now disconnected from the VPN.

Need help? Contact the ExpressVPN Support Team for immediate assistance.

Back to top

บทความนี้มีประโยชน์หรือไม่?

เราเสียใจที่ได้ยินเรื่องนี้ โปรดบอกให้เราทราบว่าควรปรับปรุงอย่างไร

Which router model do you need help with?

Examples: Linksys WRT1200AC, Asus RT-AC56R

เจ้าหน้าที่ฝ่ายสนับสนุนของเราจะติดต่อกลับเพื่อช่วยแก้ปัญหาของคุณ